Includes: Front and rear wheels, front and rear quick release
skewers. Does not include anything else. Requires rim strips, tires,
and tubes prior to use (not included).
Weight: 2.0lbs front, 2.45lbs Rear
Condition: New in box. The company that makes them is a large
wholesaler in America. Sta-Tru is their house brand of wheels.
Fits 700c or 29er tires (622mm Bead Seat Diameter) - from 700 x
20 up to 700 x 42 - the second
number is the width, the first refers to the diameter. How wide a tire
you can install depends on what type of clearance your frame has
between the seat stays and brake arms.
For rim brakes only - does not have mounts for disc brake rotors.
Not intended for use with 27" wheeled frames. They will fit, but
700c wheels are smaller in diameter than 27" and the brake pads will
not touch the rim's braking surface. Conversions are possible with
brakes with longer reach arms.
All 7 speed cassettes - Requires a 4mm wide spacer (NOT
Hub bodies made with a Shimano/SRAM spline pattern have three
7 speed hub body splines are approximately 28mm wide, and
thus the cassette is the same width.
8 thru 10 speed road hub body & 11s Shimano MTB
splines are approximately 33mm wide, so their cassettes are correspond
to that width
Not compatible with single or multi-speed freewheels, or
convertible for fixed gear single speed use. If you are unsure what the
differences between a cassette and freewheels are, we'd recommend you
research the topic prior to your wheel purchase.
Does not include adapters, nor is it convertible to any other
Ball / Cone type hubs are the most common type of hub on
planet earth. While being nearly indestructable and serviceable,
optimal performance requires maintenance. If you're looking for
optimizing performance, we advise
that the cones are adjusted to your preferences, as well as checking
cone position, and re-greasing the bearings throughout the life of the
wheel. See the last image for a general diagram of this type of hub.
The closer the two cones are on either side of the hub the more
restrictive and poor the wheel will spin. The farther the two cones are
apart, the better a hub will spin, however, it may introduce play/slop
into the bearings if they are too far apart. The perfect position is
where the axle turns with
the least amount of resistance, and has no extra space between the
cones, bearings, and hub races (has no slop or play). The lock nuts
on either side of the axle lock the cone's position in place. It is
not unique to our brand of wheels, but the design of ball / cone type
hubs. Generally, the folks at the factory err on the side of too tight
rather than loose because being slightly too tight is better than too
loose. Adjustment usually requires one cone wrench (thin wrench), and a
standard box/open end wrench for the locknut. There are loads of videos
on youtube describing the process.
For best performance prior to use, apply a drop of lube or grease
between the rubber hub seals and aluminum hub. It's not entirely
necessary, but if squeaking occurs, its from the friction between those
Spokes stretch and settle with use on ALL wheels - it is advised
to check true and spoke tension after a few rides.
We appreciate customers reading notes on brand new wheels!
Thanks! It's in both our best interests that you get the most out of
the products you purchase from us. These notes are applied to the most
common type of wheels on planet Earth - Entry to mid level